Ut700 controls and functions, Power on/off switch, Power led – Lectrosonics UT700 User Manual

Page 16: Hiding the power led, Encryption key link, Frequency select switches

Advertising
background image

UDR700 / UM700 / UT700

UT700 Controls and Functions

Encryption Key Link

Power LED

Power On/Off

Switch

Battery

Compartment

Power On/Off Switch

The Power On/Off slide switch is located on the outside
bottom of the unit and controls power to the transmitter.

Power LED

The Power LED glows green when the battery is good
and the On/Off switch is set to On. The LED glows red
as the battery voltage drops and blilnks when there is
about 30 minutes of operation left with the recom­
mended alkaline battery.

Note: A weak battery will sometimes cause the
POWER LED to glow green immediately after
being put in the unit, but will soon discharge to the
point where the LED will either glow red or the
transmitter shuts down. If the lamp fails to light,
the battery should be replaced.

Caution: A NiMH battery will give little or no
warning when it is depleted. If you wish to use
NiMH batteries in the unit, we recommend
trying fully charged batteries, noting the length
of time that the batteries will run the unit and
in the future use somewhat less than that time
to determine when the battery needs to be
replaced.

When the unit is first turned on, the Power LED also
blinks a code to indicate the current Security Level.

Level 1 - One blink

Level 2 - Two blinks

Level 3 - Three blinks

Modulation LEDs

-10

-20

Fine

Coarse

Frequency Switches

Audio Level

Control

Hiding the Power LED

This unit has no provision for disabling the LEDs. The
Audio Level LEDs are covered during normal use but
the Power LED is exposed. If the light is objectionable,
we recommend covering the Power LED with a piece of
opaque tape.

Encryption Key Link

The Encryption Key Link is used to connect the trans­
mitter to the UDR700 Series receiver to set an encryp­
tion key.

Frequency Select Switches

Two 16-position rotary Frequency Select Switches
(located in the battery compartment) are used to adjust
transmitter’s operating frequency. The Coarse switch
adjustment adjusts the frequency in 1.6 MHz incre­
ments and the Fine switch adjusts in 100 kHz incre­
ments.

Frequency Switches

Coarse

Fine

0 1

2

3

4

5

6

7

8

9

A

B

C

D

E

F

0 1

2

3

4

5

6

7

8

9

A

B

C

D

E

F

LECTROSONICS, INC.

16

Advertising
This manual is related to the following products: