Lectrosonics UMCWB - Manual (Page 10)

UMCWB
LECTROSONICS, INC. 10
This product meets the CE Compliance Standards - EN55022 and EN50082-1:1998. A copy of the Declaration of
Conformity may be requested from your dealer or by contacting the factory directly:
Lectrosonics, Inc.
Marketing Department
581 Laser Rd. NE, Rio Rancho, NM 87124 USA
tel: 505-892-4501 fax: 505-892-6243
e-mail: [email protected]
Specifications
RF Gain: 0.5 to 1.5dB
Bandwidth:
UMCWB: 537 to 768 MHz.
UMCWBL: 470 to 692 MHz
RF Outputs: Eight outputs, 50 Ohm, BNC
Isolation between outputs: 25 dB or greater
Any output can be open, shorted
or terminated without affecting other outputs.
Splitter type: Wilkinson 1/4 wave
Filtering: Two pole ceramic filter per antenna
Noise figure: 3.5dB
Third Order Intercept: +27 dBm (input or output)
Power Input: +11 to +18V DC;
Power Consumption: 2 amps max.
Antenna Connectors: 50 ohm BNC
Short Circuit Protection: Auto-reset thermal fuses
Construction: Machined aluminum panels and
housings.
Dimensions: 19” wide, 1.75” high, 6.5” deep
Weight: 5 lbs. (typical) including 4 receivers
Specifications subject to change without notice.
Accessories
ARG2 RF coaxial cable assembly, 2ft length,
BNC male connectors
ARG15 RF coaxial cable assembly, 15 ft. length,
BNC male connectors
ARG25 RF coaxial cable assembly, 25 ft. length,
BNC male connectors
ARG50 RF coaxial cable assembly, 50 ft. length,
BNC male connectors
ARG100 RF coaxial cable assembly, 100 ft.
length, BNC male connectors
ALP500 Log periodic dipole array (“shark fin”)
antenna; standard version
ALP620 Log periodic dipole array (“shark fin”)
antenna; “skeletal” body reduces wind
loading in outdoor use
ALP650 Log periodic dipole array (“shark fin”)
antenna; built-in RF amplifier with
adjustable gain
SNA600 Tunable dipole antenna; 100 MHz
bandwidth
PF25 Passive inline filter; 30 MHz bandwidth;
BNC to BNC connectors; bidirectional
PF50 Passive inline filter with bias-T; 50 MHz
bandwidth; BNC to BNC connectors
PS70 Power supply; 100-240 VAC; 13.8 VDC,
2.8 A output