Lectrosonics UMCWB - Manual (Page 7)

UHF Diversity Multicoupler
Rio Rancho, NM 7
A:
B:
C:
D:
E:
6. The power cables can be routed outside of the U-
channel cover, or routed under the U-channel cover
alongside the antenna leads.
Note: If you opt to run the power cords outside of
the U-channel along the back of the receivers, they
might be unplugged accidentally.
Installing the Wire Cover
Installing the U-channel wire cover can be difficult if the
power cables are routed with the antenna leads under
the U-channel wire cover. The cables must lay flat and
straight, and not overlap to allow the wire cover to lay
flush with the rack mount. The technique described here
is the easiest way to install the U-channel wire cover,
A) Dress the antenna and power cables so that the
bundle is as flat as possible. Make sure no wires
are on top of the metal bar.
B) Starting at the end opposite the power supply, care-
fully place the U-channel wire cover over the wiring
bundle and press down.
C) While keeping downward pressure on the U-chan-
nel, slide it to the left over the wire bundle.
D) As you move the U-channel across the bundle,
dress the cables with your other hand to make sure
the wires remain as flat and neatly aligned as pos-
sible. The power cords in particular need to lie flat
and not overlap each other.
E) While holding the U-channel down, insert the four
phillips head screws and tighten them slowly while
watching the wires to make sure none are pinched.
Installing the Assembled Unit
Mount the assembled frame into the rack, connect the
antenna and an appropriate power supply. There are no
special ventilation requirements.