Lectrosonics UT300VM - Manual (Page 13)

Frequency Agile Handheld Transmitter, Euro Model
SPECIFICATIONS
Operating Frequencies: 537.6 to 862.0 MHz in 26.5MHz blocks
RF Power Output: 10mW
Pilot Tone: 32.765 kHz, ±2 Hz, 5kHz deviation
Frequency Stability: ±0.002%
Deviation: ± 50 kHz max
Spurious Radiation: Effectively none below 1GHz, above 1GHz At least 50dB
below the carrier
Equivalent Input Noise: –126 dBv
Input Level: Maximum SPL depends on mic element used
Input Compressor: Soft compressor, >30 dB range
Gain Control Range: 43 dB, semi-log rotary control
Modulation Indicators: Dual LEDs indicate modulation level 10 dB below clipping and at the onset of limiting
Controls: • Power ON/OFF, Audio ON/OFF and Battery Condition LED
located on bottom of unit
• Bypass controls located inside battery door
• Gain control located inside battery door
• Frequency switches to adjust the transmitter frequency
in COARSE and FINE increments located just below the
mic head on the outside body of the case.
Battery Precision compartment auto-adjusts to accept any known
alkaline or lithium 9 Volt battery. (We’ve tried 150 different models!)
Battery Life Alkaline: 8 hours typical
Lithium: 18 to 20 hours typical
Weight: 13.2 ozs. with VariMic capsule and alkaline battery
Dimensions: 9." long x 2.05" diameter (at largest point) with VariMic capsule
Emission Designator: 150KF3E
Specifications subject to change without notice.
This product meets the CE Compliance Standards - ETS 300 445; January 1996
and I ETS 300 422 (December 1995). A copy of the Declaration of Conformity
may be requested from your dealer or by contacting the factory directly:
Lectrosonics, Inc.
Marketing Department
581 Laser Rd. NE, Rio Rancho, NM 87124 USA
tel: 505-892-4501 fax: 505-892-6243 e-mail: [email protected]
Rio Rancho, NM - USA 13