Lectrosonics UMC16a - Manual (Page 4)

REAR PANEL DESCRIPTION
ANT A RF OUT 12V DC IN
400MA MAX
ANT B RF OUT
100 - 240 VAC
10 WATTS
UMC16A
S/N 0000
000-111 MHz
Figure 3 - UMC16a Rear Panel
ANT A / ANT B
RF input jacks. These are standard BNC, quarter-turn twist lock connectors. Each antenna
jack is completely separate from the other.
RF OUT
RF output to receiver antenna jack(s). Each group of RF outputs is completely separate from the other.
12V DC IN
Alternate power input jack. The UMC16 can accept any DC voltage from +11 to +14.V DC.
110V AC Power Input Jack
This is a standard 3-prong AC power jack. The unit can accept any voltage in the range of
100 to 240 VAC at 10 Watts.
PHANTOM POWER JUMPERS
NOTE: These jumpers are ONLY to be used when the Lectrosonics UFM50 filter/amp module is being
powered through the antenna input jacks on the UMC16A multicoupler.
1. Unplug the power cord and place the UMC16A so that the front panel faces away from you. Remove the cover
from the UMC16A (12 screws).
2. Locate the socket for antenna B (ANT B) on the circuit board next to the power wires (see photo below left).
Install the jumper to enable DC power on the ANT B connector.
Jumper for ANT B
Input Connector
Jumper for ANT A
Input Connector
3. On the other end of the unit, locate the jumper for antenna A (ANT A). (See photo above right.)
4. Install the jumper to enable DC power on the ANT A connector.
4