Specifications, Service and repair – Lectrosonics UMC16a User Manual
Page 6
SPECIFICATIONS
Type:
Active RF distribution system with ceramic filtering
Inputs:
Two 50 Ohm BNC jack on rear panel
Third order intercept:
+27dBm at input
Outputs:
Type:
16 BNC jacks on rear panel. Eight jacks per antenna.
Isolation:
25dB min, any output to any output
Any output can be open, shorted, or terminated without
affecting other outputs.
Splitter type:
Wilkinson 1/4 wave
Frequency Range:
470 to 865MHz, factory set (See serial number sticker on
side panel for frequecny range of your particular unit.)
Filter bandwidth:
16 to 50MHz, factory set
Input/Output RF gain
1 to 2dB at center of band
Power Requirements:
95-240VAC or 11 to 14VDC
Overload protection provided by internal auto-reset circuit breaker.
Power consumption:
Nominally 110-220VAC, 10 Watts
Nominally 340mA at 12VDC
Dimensions:
19 x 7 x 1.75 inches
Weight:
2 lbs., 9ozs.
Specifications subject to change without notice.
This product meets the CE Compliance Standards - EN55022 and
EN50082-1:1998. A copy of the Declaration of Conformity may be
requested from your dealer or by contacting the factory directly:
Lectrosonics, Inc.
Marketing Department
581 Laser Rd. NE, Rio Rancho, NM 87124 USA
tel: 505-892-4501 fax: 505-892-6243 e-mail: [email protected]
6