Audio outputs, Telephone line jack, Programmable inputs – Lectrosonics SPNCWB User Manual

Page 9: Codec and tel remote control ports, Shield

Advertising
background image

Installation and Startup Guide

Rio Rancho, NM

9

Programmable Inputs

Programmable inputs are provided to enable external

control over a variety of parameters. Each input can

respond to a contact closure, a DC voltage source, or

the variable voltage output from a potentiometer. The

following illustrates common connections to the pro-

grammable input pins.

10K Linear Potentiometer

CCW

CW

+5V

To Programmable Input Pin

Gnd

Contact Closure as Programmable Input

To Programmable Input Pin

Gnd

DC Voltage Source as Programmable Input

To Programmable Input Pin

0VDC (Off) to +5VDC (On)

Gnd

Potentiometer Connection for

Analog Control of Gain

Programmable

Inputs

Programmable

Outputs

Ground

+5VDC

CODEC and TEL Remote Control Ports

These RJ-45 connectors are used with the RCWTH4

remote control module, connected with standard CAT-5

cabling. Each port is assignable to Codec 1, Codec 2 or

the telephone line.

Remote Control Ports

can be assigned to

Codec 1, Codec 2 or

the Tel LIne.

1 GND
2

Connect Button

3

Privacy Button

4

Volume Up Button

5

Volume Down Button

6

Privacy LED

7

Connect LED

8 GND

Audio Outputs

The line outputs are a balanced differential configura-

tion which can drive balanced or unbalanced inputs on

other audio equipment with the wiring shown here.
Balanced output to a balanced input is a straightforward

“pin to pin” configuration.

Destination

Output

Balanced output to

balanced destination

Shield

Balanced output to unbalanced input with a 3-wire

cable is connected with the cable shield added to the

(–) terminal on the destination input.

Destination

Output

Balanced output to unbalanced

destination – 3-wire cable

Shield

Balanced output to unbalanced input with a 2-wire cable

is connected with the output (–) connected to the cable

shield at the processor output.

Destination

Balanced output to unbalanced

destination – 2-wire cable

Output

Shield

Telephone Line Jack

Connect a standard telephone cable with RJ11 connec-

tors between the back panel Telephone Line Jack and

the host telephone system.

Advertising