Lectrosonics FM875 - Manual (Page 11)

OPERATING INSTRUCTIONS cont’d
USING HARD-WIRED MICROPHONES
Any unbalanced, dynamic microphone can be plugged into the AUX MIC INPUT.
1) Make sure the volume knobs are set at "0."
2) Plug an auxiliary cord (a MM-16 or MC-16C will work) into your microphone and into the MIC OR AUX
IN.
3) Flip the switch on the microphone and bring the AUX VOLUME up slowly to the desired volume. If
the speaker squeals, the microphone is too close to the speaker. A longer microphone cord will
reduce this noise.
TAPE RECORDING AND PLAYBACK
1) To record, connect the LINE OUT on the unit with the AUDIO IN (line input) on the tape recorder.
2) To playback, connect the AUX IN on the unit with the AUDIO OUT (line level) on the tape recorder.
Set the AUX VOLUME at about "6" then adjust the volume control on your tape player to get the
desired volume.
Not all tape recorders will work with the FM-AV4. Low cost tape recorders may not have "line level"
inputs and outputs required for quality recording and playback.
CONNECTING INTO HOUSE SOUND SYSTEMS
1) Connect MIC LEVEL OUTPUT to the house sound system. This should be a balanced microphone
level input with an XLR connector.
2) The volume of the MIC LEVEL OUTPUT is controlled by both the AUX VOLUME and the WIRELESS
MIC VOLUME depending on what audio source you are using. If using only one source, be sure to
turn the unused volume control to 0.
10 0
2
4 6
8
MODULATION
RF 20
LIM T
WIRELESS MIC
VOLUME
Red Lamp Yellow Lamp
Green
Lamp
11