Lectrosonics FM875 - Manual (Page 4)

CONTROLS AND FUNCTIONS
10 0
2
4 6
8
MODULATION
RF –20
LIMIT
WIRELESS MIC
VOLUME
OUT IN
POWER
CHARGE
MIC LEVEL
OUTPUT
LECTROSONICS
LO-Z
BAL
IN/OUT
OMNI–BUS
10 0
2
4 6
8
CHARGE UNTIL GREEN LED
GOES OUT OR LONGER
ADJUST MIC GAIN ON TRANSMITTER
UNTIL LIMIT LED FLASHES ON VOICE PEAKS
1 2
3
AUX
VOLUME
IN
AUX MIC OR AUX LINE
(Items are listed in right to left order as shown on the panel above.)
POWER: A toggle switch which turns the power off and on.
CHARGE: Jack for CH-40 charger.
POWER LED: A red LED indicates when the FM875 is turned on and the batteries are charged
up enough to operate the system. This LED will also light up when the batteries
are being recharged if the CH-40 charger is properly connected. This led will go
out when the batteries are discharged.
CHARGE LED: Lights when the unit is being charged. This green led will go out when the
batteries are fully charged.
OMNI-BUS IN/OUT: An RCA phono jack that functions both as a line level input and line level output.
This "omnibus" jack is primarily used for interconnecting several FM875s together
for simultaneous operation. This jack can also be used with a tape deck to either
record from or play back into the FM875. When used with a tape deck or other
audio source, the sound output level must be controlled by the volume control on
the tape deck since there is no volume control on the FM875 for this jack.
IN/OUT
OMNI BUS
Connect two FM875s
together using the
OMNI-BUS jacks.
OMNI BUS
IN/OUT
Male
RCA Male
RCA
FM 875 #1 FM 875 #2
When connected in this manner, the volume control knob on one unit will affect
the loudness of that source (wireless, aux, etc.) on both FM875 systems.
4