Liquid Controls DMS Setup - Manual (Page 59)

59
Device Not Found
Screen 20: Device Not Found
Once the active LCRs are set up, LCR# (F4) can be used
to switch between the active LCRs. Assuming that only
one LCR has been set up, LCR# (F4) will open a list box
window with only one item to select. If there are two LCRs
configured, the list box window will contain two items to
choose from.
If the operator opens the list box window for
LCR#, selects
an LCR, and the LCR is no longer communicating, then
Screen 20 will display, letting the operator know that there
is a problem communicating with the LCR# selected. This
may be a simple issue of a disconnected cable or power
has been removed from the LCR.
This screen will also appear anytime communication with
the active LCR is lost.
LCR #xxx not found.
Check the LCR to ensure it
has power applied and that
its communications cable is
connected to the DMS i1000.
Press F1/Dlvy or F4/LCR# when
ready to attempt to reconnect.
Dlvy LCR# Main