Liquid Controls Precision Turbine Flowmeters - Manual (Page 8)

FIGURE 1: 1/4” PRECISION TURBINE FLOWMETER
HOUSING: AN, NPT, FLANGED
5
3
2
1
6
DOWNSTREAM UPSTREAM
8
5
7
4
ENDVIEW
4
DISASSEMBLY FOR 1/4” METERS REASSEMBLY FOR 1/4” METERS
1. Remove retaining ring; Lift out carefully by placing a small flathead screw driver under the
radius notch.
2. Remove internals from housing.
3. Review all parts for damage. STOP: If any part appears damaged DO NOT
REASSEMBLE call factory for instructions.
4. Clean parts thoroughly before reassembling.
NOTE: Internals must go back together the exact way that they come out.
1. Insert cones in hangers, and bearings in rotor.
2. Assemble internals as illustrated.
3. Slide internals in housing, (position hangers as illustrated in endview).
4. Install retaining ring - Make sure it seats in groove.
5. Observe that hangers do not turn.
6. Observe that rotor spins freely.
ITEM DESCRIPTION QTY
1 HOUSING 1
2 ROTOR 1
3 BEARING 2
4 CONE 2
5 HANGER 2
6 SHAFT 1
7 RETAINING RING 1
8 PICKUP COIL 1
Pg.6