Luna Optics EBG1-PRO - Manual (Page 6)

6
TURNING THE UNIT ON AND OFF:
Your night vision unit has a
special power and IR switch
(10), which allows you to easily
switch between ON and OFF
modes, while protecting you
from accidentally switching on
the IR illuminator. To turn the
unit ON, first remove the
objective lens cover (ONLY IN THE DARK!) and rotate the switch
by one dial to ON position. Look through the oculars – you
should see green glow. Even if the image is not yet sharp, the
unit is operating. To turn the unit OFF rotate the same switch
backwards one dial to OFF position. The green glow will
disappear if you turn the unit off correctly. Always replace the
objective lens cover after the unit is turned off and no longer is
in use.
FOCUSING THE UNIT:
To obtain the sharp image, you must first rotate each ocular
wheel (6) one-by-one in either direction, until you notice in
which position the image is at its best. After that, rotate the
objective lens (12) also until the image is at its best. You may
have to repeat the process again, until the image is sharp and
clear. Once the clear image is obtained, you no longer need
to adjust the oculars, just rotate the front objective lens to
adjust the distance to the object you are viewing.
ADJUSTING DISTANCE BETWEEN EYEPIECES:
Your LN-EBG1 (EBG1-PRO)
feature adjustable oculars
(eyepieces). This feature helps
to ensure the image appears
as one circle, which provides
the most comfortable
viewing, even when using
your goggles for a long period
of time. After you turn the
power on and after you adjust the focusing to the best possible
image, make notice of the image and see if it appears as one
single circle. If it does, then there is no need to adjust the
distance between the eyepieces. If the image appears as if
one circle is on top of another, then you need to either pull
apart the eyepieces or push them in together until the image
appears as one perfect circle (see image on the right).