Magnum Venus Plastech System One FRP 3101-00-01 - Manual (Page 5)

FRP SystemOne
FRP SystemOne
Disassembly of Fluid Section
2
Chapter
2
To remove the Fluid Section from the
SystemOne Unit:
1. Remove the 8401-5-1 (E-Ring), lift up the 8401-4-1 (Sleeve) and
remove the two 8401-3-1 (Connectors).
2. Remove the 4103-1-1 (Pivot Pin Guide Bushing) to disengage the
from the 4103-7-1 (Slide Arm).
3. Remove the 7201-8-1 (Quick Pin) and slide the 4103-7-1 (Slave
Arm) out of the 3101-8-1 (Piston Rod Adapter).
When removing Resin Pump Fluid Section and Resin Surge Cham-
ber, be sure to bleed pressure from the system before disconnect-
ing hoses or tie rods. Release Surge Chamber charge before
removing Surge Chamber. System may be under pressure and
could cause injury.
WARNING
NOTE
The resin pump can be rebuilt in place or easily removed from pump
column and moved to a workbench.