Magnum Venus Plastech System One FRP 3101-00-01 - Manual (Page 7)

FRP SystemOne
FRP SystemOne
Reassembly of Fluid Section
1. Use MVP 6706-2-1 (White Grease) to fill in the female side of each
of the four Packings in the 3101-4-01 (Packing Set Assembly) and
the 3101-3-1 (Female Compression Ring). Wipe a light coat of
White Grease on the 9201-2-28 (7/8” Chrome Ball), and the 9201-2-
36 (1 1/4“ Chrome Ball). Smear White Grease on the inner radius
on both 3101-12-1 (Piston Cups). Coat the threads on the 3101-1-1
(Packing Nut) with the White Grease.
2. Insert the 3101-6-1 (Spring Support Ring) into the 3101-7-1 (Outlet
Body), followed by the ten 9203-1-1 (Wave Springs). Place the
3101-4-01 (Packing set Assembly) on top of the 3101-5-1 (Male
Compression Ring). Set the 3101-3-1 (Female
Compression Ring )
on top of the 3101-4-01 (Packing Set Assembly). Place the entire
assembly into the 3101-7-1 (Outlet Body) with the female side of the
Packing Set facing down. Set the 3101-2-1 (Guide Bearing) into
the 3101-7-1 (Outlet Body). Screw the 3101-1-1 (Packing Nut) into
the 3101-7-1 (Outlet Body) only two to three threads.
4
Chapter
3
NOTE
Do not tighten the 3101-1-1 (Packing Nut) at this time.