Magnum Venus Plastech System One FRP 1100-1-1 - Manual (Page 4)

FRP SystemOne 1
FRP SystemOne Quick List
NOTE: These instructions include resin and catalyst pressurization procedures.
To avoid equipment malfunction or possible injury, please follow these
instructions. If you have any questions, please contact our Technical Service
Department at 800-448-6035.
Chapter
1
1. Check & fill solvent system
2. Check & fill resin & catalyst supply
3. Place suction wand in resin supply
4. Prime resin pump
5. Prime catalyst pump and set catalyst percentage
6. Check system for fluid leaks
7. Set air pressure to gun/chopper
8. Install turbulent mixer in mix chamber
9. Select spray tip, flow nozzle or convergence tip
10. Check chopper motor, rubber roller adjustment
11. Attach chute & cover
12. Adjust fan pattern
13. Adjust chop pattern
Quick List Instructions
Start-Up Sheet