Magnum Venus Plastech System One FRP 1100-1-1 - Manual (Page 6)

FRP SystemOne
Chapter
2
1. Tighten all hose fittings and fluid connections to make sure they are
tight.
2. Check electrical grounds, gun to pump and pump to earth ground.
3. Check all clamp brackets, pump column, slave arm bracket, manifold
clamp, etc. To make sure they will not move when unit is in operation.
4. Check the mounting of catalyst pump to make sure clevis pins are
secure.
5. Make sure exhaust silencer is secured to the power cylinder of the
resin pump.
6. IMPORTANT: Snug up the packing nut at the top of the catalyst
pump Approximately ¼ turn.
7. Snug up, tighten, the resin pump packing be inserting two rods into
the holes in the oil cup at the top of the resin pump fluid section. Turn
clockwise until packing is snug.
8. Tighten the gun valve rod packing nut until it is very snug.
IMPORTANT: Activate the gun trigger 10 - 15 times then tighten
the packing nut. Repeat this tightening procedure 3 times to make
sure the gun valve rod packing is tight.
FRP SystemOne
Installation & Set-Up
Checklist
3