Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 31)

Classic Pro Gun Manual
Rev. 08/2012 Page | 31
Actuator Rebuild:
Actuator Disassembly
1. Remove the two o-rings (O-V-013) from the underside of the cylinder body
(58631-1).
2. Unscrew the cylinder caps (5106-4-1) from each end of the cylinder body.
3. Remove the o-ring (O-V-020) from each of the cylinder caps
4. Remove the actuating piston (5106-7-1) by pushing it out the back end (long end)
of the cylinder body with your fingers or a blunt tool.
5. Remove the actuating bushing (5106-5-1) from the piston with the packing
assembly rod.
CAUTION: Avoid damaging the actuating piston when using the scribe in the
next step.
6. Use a scribe to remove the o-ring (O-V-020) from the actuating piston.
Note: O-rings should be replaced each time the gun is disassembled.
Clean Components

Discard the used o-rings

Clean the cylinder assembly components with solvent and allow to air dry. Do
not soak actuating piston or cylinder caps in solvent as they will swell.