Magnum Venus Plastech Classic Pro Gun CPC_CPG_CPW_CPP - Manual (Page 38)

Classic Pro Gun Manual
Rev. 08/2012 Page | 38
Assemble Classic Pro Gun Modules
1. Use the two mounting screws (58626-1) to secure the handle assembly to the
actuator assembly (58604-1).
Note: The hole in the actuating bushing of the actuator must be facing up so the
bushing hole can receive the actuating stem of the gun block.
2. Using the four mounting screws (5106-6-1) secure the gun block to the actuator.
Note: The actuating stem on the gun block must be in the hole of the actuator
bushing. If you are unsure, remove the front end cap of the actuator and look.
Mounting Chopper
Note: If your Classic
Pro Gun™ is used for chopping, perform the two steps, A
and B:
A. Install the hex cap screw securing the chopper to the top of the gun block. Be
sure to install the eccentric stud in the chopper mount.
B. Attach the air tube that connects the chopper to the gun handle.