Mallory Ignition Mallory COMP STARTER - Manual (Page 3)

3
Move the starter cable from the current position on the remote solenoid to the
opposite side (same side as battery cable).
Run a 10 gauge or larger wire from the remote solenoid terminal (where the
starter cable used to be) to the small terminal on the Mallory starter solenoid.
Step 7
Vehicles with remote Solenoid (includes most Ford/AMC):
NOTE: Mallory does not recommend using a jumper wire on the
solenoid. Installing a jumper wire on a permanent magnet motor can
result in current feedback, which can cause the pinion to remain
engaged with the flywheel after the engine starts. This will result in
eventual starter failure.
REMOTE
SOLENOID
BATTERY
—
BATTERY CABLE
STARTER CABLE
——
10 GAUGE OR LARGER
2 GAUGE OR LARGER
FIGURE D WITH STOCK STARTER
STOCK STARTER
REMOTE
SOLENOID
BATTERY
— ——
STARTER CABLE BATTERY CABLE
FIGURE E WITH MALLORY COMP ® STARTER