Mallory Ignition Mallory COMP STARTER - Manual (Page 4)

4
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NEVADA 89701
(775) 882-6600 FAX (775) 887-4326
www.mrgasket.com
FORM #1434
(REV. C) 1/00
Made in U.S.A.
Printed in U.S.A.
Starter Shims
When using a starter that bolts to the engine block, it is sometimes necessary
to shim the starter to get smooth engagement. If the starter grinds (does not
engage ring gear smoothly) when the key is turned, shims may be required.
Mallory Comp ® Starters are designed to use the stock type shims available at
any auto parts store. Start with the thinnest shim. Do not use any more shims
than necessary to get smooth engagement. No more than .093" of total shims
should ever be used. If the starter still does not engage smoothly, check the
ring gear teeth for damage.
NOTE: If the starter engages the ring gear but is noisy while turning
the engine over, too many shims are being used or the ring gear/pin-
ion gear is damaged.