Adaptec SAS/SATA/SCSI RAID Controllers - Manual (Page 29)

Chapter 4: Getting Started ●
29
Cable connectors are keyed so that you can’t insert them incorrectly.
Adaptec recommends using only Adaptec SAS cables. For more information or to purchase
cables, visit the Adaptec Web site at
www.adaptec.com .
SATA Cables
You need one straight connector to straight connector SATA cable for each disk drive you are
connecting to your Adaptec SATA RAID controller. SATA cables are included in the kit.
All SATA straight connector to straight connector cables have the same connectors, as shown
in the following figure, and the connectors are keyed so that you can’t insert them incorrectly.
Adaptec recommends using only Adaptec SATA cables. For more information or to purchase
cables, visit the Adaptec Web site at
www.adaptec.com .
SCSI Cables
Depending on your requirements, you may need one or two internal cables. You may also need
one external SCSI cable. Ensure that you have cables with the proper connectors for your
RAID controller. One internal SCSI cable is included in the kit.
Adaptec recommends using only high-quality Ultra320-rated cables with multimode
terminators for all disk drives that share a channel with Ultra320 disk drives. Avoid poor quality
cables, as they may degrade reliability. Do not use cables not rated for Ultra320 operation.
Adaptec recommends using only Adaptec SCSI cables. For more information or to purchase
cables, visit the Adaptec Web site at
www.adaptec.com .
Internal mini-SAS to SATA fan-out (SFF-8087 to 4x SATA)—
Connects to four SATA disk drives.
Internal SCSI cable—Connects to up to seven internal SCSI
disk drives and devices.
External SCSI cable—Connects to an external SCSI disk drive
or device.