Micromod Micro-DCI: 53SU6000 COMMUNICATIONS SERVICES - Manual (Page 18)

53SU6000 INSTALLATION AND SETUP GUIDE
10 Introduction
0x290, 0x300, 0x310, 0x380, 0x390 and 0x3A0.
3.4 Hardware Installation
3.4.1 Supervisor Board Installation
The Supervisor board for the ISA bus is an optional Micro-DCI network communication printed circuit
board. The Supervisor board provides the software products running on PC with the ability to communicate
with the Micro-DCI Networks. (If your 53SU6000 is not equipped with Supervisor boards, you may skip to
Section 3.4.2 .)
3.4.1.1 Mechanical Specification
The Supervisor board is a rectangular board measuring 12.3 inches by 3.9 inches.
Figure 3-5. System Information Window, I/O Addresses Displayed
✎ NOTE
One full-size ISA bus slot must be available for each Supervisor
board installed in the personal computer on which the 53SU6000
software will be used. An additional half-size ISA bus slot is
required immediately to the right of each MicroLink Supervisor
board for which a redundant network connection is required.