Minuteman C45014-02 Ambassador Junior International 240V - Manual (Page 4)

3
USER MAINTENANCE INSTRUCTIONS
All service and repair should be performed by qualified vacuum service representative or
electrician. No user serviceable components are employed in the electrical system. No
lubrication of the motor is required.
DAILY MAINTENANCE
1. Solution tank should be emptied after each use. Flush pumping system with 2 or
3 gallons of clean hot water.
2. Check and clean vacuum inlet filter (page 7, item 116) and solution inlet strainer
(page 7, item 40) daily.
3. Removable recovery tank, page 7, item 8, should be rinsed clean daily.
4. Spray jets should be checked for correct spray pattern and cleaned if plugged
(page 7, item 123). Spray jets are quick release 1/4 turn type. By twisting item
121 1/4 turn counter clockwise, jets can be removed for cleaning. Do not clean
out spray tips with pins or wire, this may cause damage to the jet spray pattern
and cause streaking.
5. Protect equipment from freezing. Severe pumping system damage can occur if
allowed to freeze.
6. Inspect vacuum hoses for tight connections. Check electrical cable for abrasion
or cuts in jacket. Cord should be replaced if worn or damaged.
MONTHLY/BI-MONTHLY MAINTENANCE
The Ambassador Solution Pump System should be purged twice monthly to remove alkaline
residue build-up. The system should be flushed twice, once with the jets installed and once
with jets removed. To flush system out, use 1 quart of white vinegar to two gallons of clean
hot water, followed by a clear 2 gallon rinse. Clean spray jets if required.
CORD STORAGE
While not in use storage can be accomplished by winding cord around rear of machine.
Cord hooks are provided.
• Do not use with damaged cord or plug. If appliance is not working as it should, has
been dropped, damaged, left outdoors, or dropped into water, return to service center.
• Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around
sharp edges or corners. Do not run appliance over cord. Keep cord away from heated
surfaces.
• Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or appliance with wet hands.
This equipment should be stored indoors and not exposed to rain.