Mirion Technologies M353 Pneumatic Automatic Retract System User Manual

Page 2

Advertising

315 Daniel Zenker Drive
200 IST Center
Horseheads, NY 14845
USA
T +1.607.562.4369
+1.800.432.1478
F +1.607.562.4392

Station Road
Alton, Hampshire
GU34 2PZ, UK
T 01420.541600
F 01420.541700

19501 144th Ave NE
Suite C400, Woodinville
WA 98072, USA
T +1 425 487 3385
F +1 425 4873375

The above specifications may vary according to system configuration.
Mirion Technologies Incorporated reserves the right to amend or change the
information on this sheet without prior warning.
03/09

RETRAcT

cylinder

2” (51mm) bore with steel rod;
Standard
/AL12 - 12” (305mm) stroke
Optiona:
/AL18 - 18” (457mm) stroke
/AL24 - 24” (610mm) stroke
/AL30 - 30” (767mm) stroke

Air Requirements

Minimum 30 psig (207 kPa); maximum
inlet presssure 160 psig (1103 kPa)

Power Specification

115/230 VAC, 50/60 Hz

Ambient Temperature

-40°F to 160°F (4°C to 71°C)

Retract Rail

All aluminum construction;
Standard:
/RL42 - 42” (1067mm) rail
/RL30 - 30” (762mm) rail
/RL54 - 54” (1372mm) rail
/RL66 - 66” (1676mm) rail
/RL78 - 78” (1981mm) rail

SPEcIFIcATIonS AnD PERFoRMAncE

RESERvoIR

Dimensions

Clearance envelope;
16.5”W x 13.65”H x 5”D
(419mm x 347mm x 127mm)

Mechanical

1/2” NPT female threaded inlet, five mi-
cron filter, check valve at inlet to allow
one-way air flow

Air Hose

Aeroquip SH925 (5 meters)

Air Storage

Reservoir stores enough air for 1
retraction of the 30” (762mm) stroke
cylinder @ 40 psi (276 kPa)

conTRollER

operation Modes

Automatic retract when air pressure
drops below a set level or if power fails.
For water cooled lens: Retracts when
cooling flow drops below a set level.
Camera can also be manually retracted
and inserted by the operator.

Min. Air Pressure Set Point

Factory preset to 2.5 psig (17 kPa) min.
lens pressure

Min. Water Flow Set Point

1 gpm

SAMPlE REPRESEnTATIon: 12” RETRAcT AnD
72” RAIl

Top Figure

The pneumatic retract is fully inserted
into the process.

Middle Figure

The pneumatic retract has retracted
the lens 12 inches (305mm) from the
heat of the process to the end of the
cylinder stroke.

Bottom Figure

The lens and camera have been manu-
ally pulled back to the length of the
extended rail.

conTRollER

controller Ambient Temp.

32°F to 130°F (0° to 54°C)

Physical Dimensions

10”W x 12”H x 5”D
(254mm x 305mm x 127mm)

Enclosure Specifications

IP66 (prior to modification) to EN 60
529/10.91
Sheet steel, dipcoat primed and pow-
der coated in textured RAL 7032

Advertising