MIDLAND CT710 - Manual (Page 3)

4 | CT710 Instruction Guide CT710 Instruction Guide | 5
Content:
• CT 710 transceiver
• Antenna
• Li-ion battery pack 1600mAh
• Belt clip
• Desktop charger with wall adaptor
• Quick Guide
If any items are missing or have been damaged during shipment, please
notify your MIDLAND dealer.
Maintenance
Your transceiver is an electronic product of exact design and should be
treated with care .The suggestions below will help you to fulfill any war-
ranty obligations and to enjoy this product for many years.
• Do not attempt to open the unit. Non-expert handling of the unit may
damage it.
• Do not store the radio under the sunshine or in hot areas. High tem-
peratures can shorten the life of electronic devices, and warp or melt
certain plastics.
• Do not store the radio in dusty and dirty areas.
• Keep the radio dry. Rainwater or damp will corrode electronic circuits.
• If it appears that the radio diffuses peculiar smell or smoke, please
shut off its power immediately and take off the charger or battery
from the radio.
• Do not transmit without antenna.
Main functions
• Dual band (VHF/UHF) displayed
• Frequency band:144-146MHz & 430-440MHz (Rx / Tx).
• Working mode: UHF-VHF, VHF-VHF or UHF-UHF
• Output power: 5W VHF /4W UHF
• 128 stored channels
• Scrambler (levels can be programmed via software)
• Compander (programmable via software)
• VOX function
• 210 DCS codes and 50 CTCSS tones
• “VOICE” function
• SOS emergency function
• Channel spacing selectable between 25kHz and12,5 kHz
• Following options can be shown on the display: channel name +
channel number, channel number + frequency, channel number, or
frequency
• Inverted frequency function
• Scan function
• FM radio receiver
• Frequency Step: 5 kHz, 6.25 kHz, 10 kHz, 12.5 kHz, 25 kHz,
• Selectable tx power: high (4-5W)or low (1W)
• Li-Ion battery pack 1600mAh
• Frequency Offset: 0-69.950 MHz
• Shift repeater
• ”Busy channel lockout” frequency (programmable via software)
• Tx signal strength indicator on the display
• Low battery vocal indication
• Roger Beep tone at the beginning or end transmission
• TOT (Time out timer)
• Keypad lock
• Scan of frequencies with CTCSS/DCS
• Scan priority
• DTMF
• Reset of functions and channels
• 1750 / 1450 / 2315 tone to connect to repeaters (programmable via
software)
• Jack for external speaker/mike: 2 Pin KenWOOD type