Dings Dynamics Group 60 Series Coupler NEMA 4 - Manual (Page 8)

VERTICAL MOUNTING
Installation and Adjustment
Installation and adjustment of the vertically mounted brake
is the same as on the standard model.
Friction Disc Replacement
When replacing friction discs, follow procedure outlined
on page 5 with this addition:
Care must be taken to insure proper insertion of disc
separating springs. Springs are color coded for easy
identification, and reference is made to spring color (see
Fig. 8 and 9). Since the installation order of the disc springs
is dependent on brake mounting position (above or below
motor), it is important to consult the correct diagram for
spring location.
Qty. of Parts
(determined by no. of
Item Part rotating discs)
No. Description No. 1 2 3
1 Spring (silver) G060350-001 2 2 2
2 Spring (black) G060350-002 - 2 2
3 Spring (bronze) G060350-003 - - 2
4 Roll pin - 1/8” x 5/8” W005003-071 2 - -
5 Roll pin - 1/8” x 1” W005003-077 - 2 -
6 Roll pin - 1/8” x 1-3/8” W005003-080 - - 2
7 Stationary disc H060203-003 1 1 1
8 Stationary disc H060203-004 1 2 3
9 Adapter housing with drain L060393-004 1 1 1
for Models VU4-60000-5153
only (not shown)
Figure 8 Parts for Vertical Mounting
Figure 9
8