DoorKing 1802 Entry System - Manual

1802-EPD Heater Kit
Part Number 2600-582
IMPORTANT!
Power the heater assembly only from the 16 V, 20 VA transformer supplied. Do not power the
heater from the telephone entry system power transformer.
The 2600-582 Heater Kit allows the 1802-EPD Telephone Entry System LCD display to maintain
normal operation to approximately -20°F (-29°C). The heater assembly has a built-in thermostat that
will automatically turn the heater on when the temperature drops below 40°F (4°C).
1
2
3
1 ea. Heater Assembly
1 ea. Transformer 16 V, 20 VA
2 ea. Wire Nuts
2 ea. Screws
2 ea. Nylon Washers
2600-582 Heater Kit
Remove Screw
Remove the two (2) screws from the
lower part of the display board.
Install the heater assembly using the
two screws and nylon washers
supplied. The nylon washers MUST
be installed between the heater
assembly and the display circuit board.
Connect the heater assembly wires to the 16
V, 20 VA transformer using the wire nuts
supplied. DO NOT power the heater
assembly from the telephone entry system
power transformer.
P/N 2338-065 REV A 10/07 Page 1