NetMedia UTPEYE-DW - Manual (Page 2)

MAN-UTPEYE REV1002A
NM-UTPE
YE
NM-UTPEYE
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: [email protected] www.netmedia.com
Figure 2 - Connecting the camera to multiple pieces of video equipment. Every piece except the last must have a
loopback or video output jack.
Figure 3 - Connecting the camera to a modulator for whole house distribution and standard television viewing on
the modulated channel. The modulator can also be the last piece of equipment in Figure 2.
Installation Procedures:
1. Connect a UTP cable (CAT5 or better) to the UTP jacks of the camera and Video Decoder. Each camera/decoder pair
needs a dedicated point-to-point wiring circuit. If attaching your own plugs, wire them for straight-through connec-
tions: pin1 to pin1, pin2 to pin2; pin3 to pin3, etc. For standardization, you should also follow the T-568A color specifi-
cation but it will not affect the camera’s function. Do not connect the UTP cable to computer networks or other
UTP video systems! Doing so could damage this product and/or the other attached devices!
2. Connect a video cable from the viewing device (monitor, Quad, DVR, modulator, etc.) to the Decoder’s RCA Video Out
jack. Simple adapters, such as RCA to BNC, may be used where appropriate.
3. Connect the 24V DC 200mA Power Transformer from an AC outlet to the Decoder’s Power Input Connector.
4. Insert the Interior Base through the 2.65” hole of the mounting surface and loosely fasten with the Bezel Ring. Adjust
the Camera Eyeball for proper viewing then securely tighten the Bezel Ring.
DO NOT CUT OR SPLICE THE CAMERA’S CABLES. MODIFYING THE UNIT IN ANY WAY WILL VOID THE WARRANTY.
Figure 1 - Connecting the camera to a security monitor or standard television. Use the TV’s composite RCA Video In
jack and view through its video or line input. The picture will not be available on a channel.
Camera
Video Cable UTP Cable
Monitor
or
Television UTP Video Decoder Module
Up to 1000 Feet
UTP Cable
Monitor
or
Television
Quad.
Sequencer
or
DVR
To Next
Device
UTP Video Decoder Module
Camera
UTP Cable
AMP
Main cable or
antenna
Modulator
Amplifier
Television
Television
UTP Video Decoder Module
Distribution
Panel
or Splitter
Splitter/
Combiner
Camera