NetMedia iViewHD-2M - Manual (Page 31)

Informational and Error Messages
You will encounter several informational and error messages as you use iViewHDʼs setup web pages.
These messages will appear after you have clicked on a form button on a web page. The message
are
Factory defaults are being set. Please wait...
You have requested that the iViewHD is set back to its factory default state. Persistent storage is be-
ing cleared. This operation will take about a minute.
Parameters set OK
You have requested changing some parameters that did not require restarting iViewHD. For example,
changing serial port parameters or controlling the Link LED will give this message.
Restarting. Please wait...
You have requested to change some iViewHD parameters that have resulted in iViewHD restarting.
Most parameters that are changed in iViewHD require a restart. You will also get this message if you
clicked on “Restart iViewHD” in the Admin web page.
Bad flash file.
The flash file you attempted to update iViewHD with was either corrupt or some kind of network error
caused the file to be received incorrectly. Make sure you are sending a valid flash file to iViewHD. If
you have verified that the flash file sent to iViewHD is valid, then try updating iViewHD again with the
same file. You may also get this message if your web browser does not correctly upload files. You
could try switching to a different browser.
Bad request from browser or file not found.
You have requested a page on the iViewHD that does not exist or your browser has sent a command
that iViewHD does not recognize.
Error setting parameters
There was an error in setting the parameters. Try the command again. You may also get this error if
iViewHDʼs persistent storage is full.
Firmware received OK. Reflashing, please wait...
iViewHD has determined that you are attempting to upload a firmware file and that it was received
with no errors. iViewHD will now re-flash its persistent storage with a copy of the newly received firm-
ware. This operation will take several minutes.
Website feature/version mismatch
The website you uploaded to iViewHD is not compatible with the firmware currently running in
iViewHD. This error is usually caused by attempting to load a website version into iViewHD that is ei-
ther too old or too new. iViewHDʼs firmware is feature locked with certain website versions. If you at-
tempt to load a website which does not have a compatible feature set, then you will get this error
message.
iViewHD Userʼs Manual
© 2009 NetMedia, Inc. 31