NetMedia MODEYE-DN - Manual (Page 2)

NM-MODEYE
NM-MODEYE
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: [email protected] www.netmedia.com
MAN-MODEYE REV1002A
DO NOT CUT OR SPLICE THE CAMERA’S CABLE. MODIFYING THE UNIT IN ANY WAY WILL VOID THE WARRANTY.
Installation Procedures:
1. Unscrew the Exterior Ring and remove the Camera Eyeball from the camera assembly. Locate the Modulator switch bank
and set the channel as shown in Figure 1. Choose an unused channel that matches the tuning mode of the televisions.
With antenna tuning, choose a UHF channel from 14-69. With cable tuning, choose a CABLE channel from 70-94 or 100-
125. There must be at least one blank channel on either side of the modulated channel to separate it from any other
broadcast, cable, or modulated source. When combining with cable service, be aware that digital data typically interferes
with channels 80-117, even when not subscribed to digital services. Channels 120-125 often work without any filtering.
2. Connect a coax from the camera’s Video/Power connector to the “MOD” side of the Power Injector. Connect the “TV” side
of the Power Injector to the grounded coax from a television or distribution system. Connect the 12V DC 300mA power
supply to an AC outlet and the Power Injector. The camera picture is now available on the programmed TV channel.
3. Insert the Interior Base through the 2.65” hole of the mounting surface and fasten with the Mounting Ring. Adjust the
Camera Eyeball for proper viewing and tighten the Exterior Ring.
80 40 20 10 8 4 2 1
ON
OFF
CABLE Channel 125 Add the numbers
printed on the
circuit board.
80 40 20 10 8 4 2 1
ON
OFF
UHF Channel 25
Figure 1 - Setting the modulated channel with the switches. Valid channels are UHF 14-69, CABLE 70-94, 100-125.
Figure 3 - Connecting the camera to a satellite system and distributing to multiple televisions.
Figure 2 - Connecting the camera to an antenna or cable service and distributing to multiple televisions.
Dual LNB
Satellite
Satellite
Multiswitch
w/Ant input
Satellite
Diplexer
Television
Satellite Receiver
Sat In
Ant In
Power Injector Camera
Main cable or
Antenna
Television
Television
Power Injector
Distribution
Panel
or Splitter
Camera
Optional Ch. 70-74 Filter
when there are no clear cable channels.
Splitter/
Combiner