AEG EE1000000 - Manual (Page 21)

Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
3. Close the oven door until the first posi-
tion (angle approximately 45°).
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an upwards angle.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure in reverse.
The number of glass panels depends on the model.
CAUTION!
Put the oven door with the outer side down on a soft and level surface to prevent scratches
Removing and cleaning the door glass panels
1. Remove the oven door.
2. Hold the door t (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
3. Pull the door t to the front to remove it.
4. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
A
A
B
What to do if… 21