Nova-Tech 5040 TRACEABLE 100-HOUR TIMER - Manual (Page 2)

2. Two channels count up, two channels count down. (Clear T1 and T2 to
00:00 00, set T3 and T4. Press and hold ENTER, then press
START/STOP.)
3. Three channels count up, one channel counts down. (Clear T1, T2, and
T3 to 00:00 00, set T4. Press and hold ENTER, then press
START/STOP.)
CHANGING MODES
During any timing event, SELECTOR SWITCH may by moved to any desired
position without affecting timing functions in other modes.
ALL OPERATIONAL DIFFICULTIES
If this timer does not function properly for any reason, please replace battery
with a new, high-quality battery (see “Battery Replacement” section). Low
battery power can occasionally cause any number of “apparent” operational
difficulties. Replacing battery with a fresh new battery will solve most
difficulties.
BATTERY REPLACEMENT
An incorrect display, no display, or operational difficulties indicate that battery
should be replaced. Use a coin to open battery cover on back of timer (turn
cover approximately ⅛ of a turn counter-clockwise). Insert battery with
positive (+) side facing up. Replace battery cover. Replacement battery Cat.
No. 1039.
Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714
Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.
Control Company Cat. No. 5030. Rev. 3 040808
Traceable
® is a registered trademark of Control Company
© 2008 Control Company