Control Company 4370 FOOD/WATERPROOF/PIERCING/DROP-PROOF THERMOMETER - Manual

SPECIFICATIONS
Range:
-58 to 572 °F and -50 to 300 °C
Resolution: 0.1° from -20° to 200°
1° otherwise
Accuracy: ±1° C from -20° to 100° C
(Model 4370)
±0.4° C at tested points
(Model 4369 Ultra™)
OPERATION
1. Press the ON/OFF button to turn the unit
on. Press the °F/°C button to switch
between Fahrenheit and Celsius.
2. Insert the probe into the material to be
measured and read the display.
3. Press the ON/OFF button to turn the unit
off. To conserve battery life, always turn
the unit off when not in use.
ULTRA™ THERMOMETER ACCURACY
Ultra™ thermometers are tested at selected
test points to be within tighter than normal
tolerances to assist in providing improved
accuracy. Other points will not necessarily fall
within the same accuracy as those found at
the selected test points, but will be within an
accuracy of ±1° C. ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly
for any reason, replace the battery with a
new high quality battery (see the “Battery
Replacement” section). Low battery power
can occasionally cause any number of
“apparent” operational diffi culties. Replacing
the battery with a new fresh battery will solve
most diffi culties.
TRACEABLE
FOOD/
WATERPROOF/
PIERCING/
DROP-PROOF
THERMOMETER
INSTRUCTIONS
Control Company Cat. No. 4369 & 4370
Traceable ® and Ultra™ are registered trademarks/trademarks
of Control Company.
© 2008 Control Company. 92-4370-00 Rev. 4 12112008
®
BATTERY REPLACEMENT
Erratic readings, a faint display, or no display
are all indicators that the battery must be
replaced. To replace the battery, remove
the three battery cover screws. Remove the
battery cover. Replace the exhausted battery
with a new 1.5-volt, silver oxide, #357 size
battery. Make certain the positive (+) side
is visible. Replace the battery cover and
battery cover screws. Do not over-tighten the
screws as this may damage the unit.
NOTE: When replacing the battery cover, ensure
the screws are tightened securely to maintain the
unit’s water-resistance.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.control3.com
Control Company is ISO 9001 Quality-Certifi ed by
DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.