Software specifications, Mounting, Chapter 2. wiring diagram and network setting – Pach and Company Quantum QWCM User Manual
Page 3: Network, user name and password default setting
PRODUCTS SELECTION
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202011-1/online_manual/qwcm_manual-2.htm[1/17/2012 9:28:32 AM]
Mounting: Magnetic mount Inside the Quantum Series Cabinet
Communication: Ethernet RJ-45 10/100M, RS-232
1.2 Software Specifications
Built-in software browser
1.3 Mounting
The QMCM must be mounted inside the Quantum Series cabinet. The QWCM is mounted using a sticky on
magnet on the right side opening of the Quantum QR5 and QC1.
CHAPTER 2
Wiring Diagram and Network Setting
A basic knowledge of networking is required to install the QWCM. Pach and Company technical department will
not be responsible configuring your network system. You may contact the Information Technology (IT)
department or consultant to configure your network.
The QWCM can be used to program the Quantum Series as
2.1 Network, User name and Password Default Setting
IP ADDRESS: 192.168.1.230
SUBNET MASK: 255.255.255.0
DEFAULT GATEWAY: 192.168.1.1
DNS ADDRESS: 192.168.1.1
User Name:
Administrator ( cannot be changed)
Password:
8888
(can be change to user preference, password can be number, character or
combination of both up to 15 digit)