Pach and Company AeGIS 8000P Series Manual - Manual (Page 11)

AeGIS8000P Page 11
Chapter 2
INSTALATION WIRING DIAGRAM
Checking your installation
1. Turn the “Power” On, the display will go into cycle mode as show
2. Check for the tone on the keypad buttons 0-9, # and *
3. Clear the memory.
4. Adjust the speaker volume, press # wait for dial tone, clockwise-decrease, counter clockwise-increase
refer to figure 2.1
5. Adjust the display intensity refer to figure 2.1
LCD DISPLAY OK FLASH OK DTMF OK
INIT START COMPLETE . . . Welcome to Pach’s
WARNING: IF THE DISPLAY SHOWS BLANK SCREEN, TURN THE SYSTEM IMMEDIATELY
REFER TO FUNCTION CODE 50 TO CLEAR SYSTEM’S MEMORY
Figure 2.1