Pach and Company AeGIS NPB9000 Series Quick Guide - Manual (Page 8)

AeGIS NPB9000 Series Programming Guide
LOCAL PROGRAMMING
1) PRESS 0 AND # SIMULTANEOUSLY THEN RELEASE , the display screen stops scrolling (If the display screen is still scrolling repeat this step again) then
enter the valid 4-digit Master Code (default Master Code: 0000). Now, you are in programming mode and see table below to continue.
2) IF YOU DO NOT HAVE A VALID MASTER CODE , open the panel (key must be used) then press and release the “RED BUTTON” on the board and the
display shows: x x x x: 4-digit Master Code, then press #. Now, you are in programming mode and see table below to continue.
SYSTEM’S OPERATION KEYPAD LAYOUT
TO PLACE A CALL FROM THE AeGIS NPB9000 Series: • Press 3 to scroll the tenant name
from A to Z. o r Press 6 to scroll the tenant name from Z to A, then press #.
TO PLACE A DIRECT CALL: Press # , wait for a dial tone then press the 2, 3 or 4 digit directory
number.
TO GRANT ACCESS TO VISITOR: Press 9 or 8, can be programmed on Function Code 43
TO USE THE 4-DIGIT ACCESS CODE: Press * then the 4-digit code.
TO USE THE PROXIMITY WIEGAND CARD READER: Place the card on the red LED, if the
card is valid door will open.
TO USE THE CARD AND THE KEYPAD ACCESS CODE: Place the card on the red LED then
press the 4-digit keypad access code.
TO EXTEND THE TALK TIME: Tenant must press the # after the time-out warning beep, the talk
time will be extended to another cycle.
TO Use the Call Waiting: Press 0 to answer the call and put the existing call on hold.
See manual for
more detail
FUNCTION CODE TABLE
CODE DESCRIPTION CODE DESCRIPTION
*
#
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
Exit the programming (local programming) or clear
the existing field
To accept program.
Replace System Master Code.
Change Talk Time
Open Interval Relay 1 and relay 2
Lock-out Count
Not applicable
Single or Multi Systems
System ID
Remote Enable or disable
Relay 2 Mode
Not applicable
Manual Unlock/Lock or Unlock hold doors timer
Edit Welcome Screen Display
Set Time and Date. Manual setting daylight saving
Time Zones
Holiday Schedules
Auto Unlock Schedules
Reinitialize Time Zone Schedules
Reinitialize Auto Unlock Schedules
Reinitialize Holiday Schedules
19
20
21
22
23
24
25 AND26
27
28
29
30
31
32
33
40
41
42
43
46
50
78
Reinitialize Holiday Schedules
New Tenant Code (Directory Code)
Modify Tenant Code (Directory Code)
Delete a Tenant Code (Directory Code)
Clear All Tenants
Card and Code
Facility Code
RS-232 or Modem
Directory Digit
Alarm Delay
Add Keypad Access Code and Card Number
Modify Keypad Access Code and Card Number
Delete Keypad Access Code and Card Number
Clear All Keypad Access Codes and Card
Master Code Mask
Open Door Beep
Not applicable
Open Door 1 and Door 2 Number
Display System Information
Clear the EEPROM Memory to Factory Default
View Directory by Name