APW Wyott 1848 User Manual
Page 14
1.
Hobart furnishes a gasket or seal that must be
placed around the perimeter of the hole in the
top as shown in Fig. 3. This gasket may be
temporarily held in place with tape. Do not
place the staple securing the gasket ends on
or near a corner.
2.
A number of clamps, such as the one shown
in Fig. 3, appear at intervals along the
perimeter. Pull clamps outward so that the
griddle frame clears them when it is dropped
into place.
3.
Drop the griddle into position by lowering it
into the fixture top hole. Make sure that the
thermostat capillaries are not kinked or
pinched when setting the griddle in place.
With the griddle in place, the gasket or seal
becomes compressed. See Fig. 4.
4.
Slide the clamp inward so that it engages the
upper part of the protruding angle from the
griddle body frame. See Fig. 5.
Slide the clamp sideways so that the notch on
it locks against the reinforcement angle. This
prevents the clamp from sliding out.
5.
Tighten the clamp screws against the angle
as shown in Fig. 5.
This tightening forces the clamp to press
down on the griddle body frame extension.
The griddle top is now drawn close to the
fixture top, compressing the gasket and
forming an effective grease guard. Tighten at
least one screw on each side before
tightening all screws. Do not exceed 60 in.-
Ibs. torque when tightening bolts.
6.
Slide the tray slide (grease drawer
receptacle) through the cut-out hole on the
apron or front of the fixture, resting it on the
two "U braces.
7.
Mount the thermostats to the control panel
and make the pilot light connections per the
accompanying wiring diagram. Before
making any electrical connections, check
nameplate voltage (located on tray slide
under grease drawer) to ensure it matches
voltage being applied.
8.
Set the control panel in place and screw it to
the apron, using the 1/2" long thread-forming
screws.
9.
Pull the tray slide against the back of the
control panel and secure it with the
appropriate screws.
10.
Slide the grease drawer into place.
14