Bosch TCC78K751 Edelstahl Kaffeevollautomat - Manual (Page 55)

English | 57
Bosch TCC78K751 | 07/2011
Calc‘n‘Clean
Calc‘n‘Clean combines the separate func-
tions of descaling and cleaning. If the two
programmes are both due to run soon, the
fully automatic espresso machine suggests
this service programme automatically.
If the prompt Service - Calc‘n‘Clean is dis-
played, press and hold down k (9) for at least
three seconds. The display shows:
Calc‘n‘Clean
Start with O
or
To start without the prompt (see „Displaying
Settings”) press and hold down k (9) for at
least three seconds and select
Calc‘n‘Clean
Start with O
Press o start/stop (10). The display will
guide you through the programme.
Empty drip tray
Empty the drip tray (22).
Replace drip tray
Replace the drip tray.
If the milk frother is not inserted,
the following message is displayed:
Set up milk frother
Insert the milk frother (12)
Place container under milk frother
Press O
Place a container with a capacity of at
least one litre under the milk frother (12).
Press o start/stop (10). The appliance
rinses twice:
Cleaning
Open drawer
Deploy the appliance and open the
drawer (19).
Insert cleaning tablet!
Close drawer!
Drop a cleaning tablet in the drawer and
close the drawer again.
If the water ilter is activated, the
following message is displayed:
Remove filter
Press O
Remove the water filter and
press o start/stop (10).
Add 0.5 l water and descaler
Press O
Pour lukewarm water into the empty
water tank (14) up to the calc (0.5 litre)
mark and dissolve two descaling tablets
in it. Press o start/stop (10).
The descaling programme now runs for
about 20 minutes:
Descaling
If there is not enough descaling
luid in the water tank, the fol-
lowing message is displayed:
Not enough descaling fluid
Refill fluid
Press O
Pour lukewarm water into the empty
water tank (14) up to the calc (0.5 litre)
mark and dissolve two descaling tab-
lets in it. Press o start/stop (10). The
descaling programme will continue.
Clean and refill water tank
Press O
Rinse the water tank and reill it with
fresh water up to the “max” mark.
Press o start/stop (10).
The descaling programme will now run
for about 1 minute:
TCC78K751_Heft1.indb 57 28.06.2011 11:44:26