AT&T E2912 - Manual (Page 19)

16
Telephone operation
16
TONE
MUTE
DELETE
REDIAL
PAUSE
TONE
MUTE
DELETE
REDIAL
PAUSE
Intercom
Use the intercom feature for conversations between
handsets.
1. Press
INT. The screen of the originating hand-
set will show CALLING OTHER HANDSET. The
destination handset will ring, and its screen will
show
OTHER HANDSET IS CALLING.
NOTES:
•
Before the intercom call is answered, you can cancel the
intercom call by pressing OFF/
CLEAR
or INT.
•
If the destination handset is not answered within 100
seconds or if it is in the directory or call log mode, or out
of range, the originating handset will show the message
NOT AVAILABLE.
2. On the ringing destination handset, press
PHONE/
FLASH
,
INT
,
SPEAKER
, or any dial pad key (0-9, * or #) to answer
the intercom call.
NOTE
:
On the ringing destination handset, pressing OFF/
CLEAR
or MUTE/
DELETE
will temporarily silence the intercom ringer.
To end the intercom call:
• Press
OFF/
CLEAR
or INT on either handset.
-OR-
• Place either handset in the charger or telephone
base.
Handling incoming calls
The telephone will beep if you receive an outside call
during an intercom conversation. You can either:
• Press
PHONE/
FLASH
to end the intercom call and
answer the incoming call.
-OR-
• Press
INT or
OFF/
CLEAR
to disconnect the inter-
com connection without answering the incoming
call. The incoming call will continue to ring.
INTERCOM
CALLING
OTHER HANDSET
HANDSET 1
12:45PM