Bosch TDS1624000 weiß Flieder Dampfstation Sensixx B10L - Manual (Page 13)

13
BOSCH
EN
gl
ISH
Description
1. Boiler´s cap
2. Removable iron pad
3. Mains cable and hose storage compartment
4. Mains cable
5. Steam hose
6. “Steam ready” pilot light
7. “Refill boiler” pilot light
8. Variable steam control *
9. Illuminated main power button (0/I)
10. Housing with internal steam generator
11. Temperature control knob
12. Steam release button
13. Iron pilot light
14. Soleplate
15. Steam button lock *
16. Filling funnel
17. Carrying handles
* model dependent
a
preparation
1. Remove any label or protective covering from
the soleplate.
2. Place the appliance horizontally on a solid,
stable surface. You may remove the iron pad
(2) from the appliance and place the iron on it
on another solid, stable, horizontal surface.
Never rest the iron on the appliance without
the iron pad!
3. Open the boiler´s cap (1). Fill the boiler
carefully using always the funnel, and close
the cap firmly.
Filling with warm water reduces the waiting
time for heating up.
Do not overfill the boiler.
4. Unwind the mains cable (4) fully and plug it into
an earthed socket.
5. Switch the main power button (9) on (position “I”)
6. The “Steam ready” indicator lamp (6) will light
up after approximately 7 minutes, indicating
that the appliance is ready to use.
7. This appliance has a water level sensor. The
“Refill boiler” indicator (7) will light when the
boiler is empty.
Remark : if the boiler is empty, both indicator
lamps (6 and 7) may light up simultaneously.
Fill the boiler as indicated in paragraph
“Refilling the boiler”.
• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an
earthed socket. If it is absolutely necessary to
use an extension cable, make sure that it is
suitable for 16A and has a socket with an earth
connection.
• If the safety fuse fitted in the appliance blows,
the appliance will be rendered inoperative. To
restore normal operation the appliance will
have to be taken to an authorised Technical
Service Centre.
• The appliance must never be placed directly
under the tap to fill the water tank.
• Unplug the appliance from the mains supply
after each use, or if a fault is suspected.
• The electrical plug must not be removed from
the socket by pulling the cable.
• Never immerse the iron in water or any other
fluid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.)
Important:
▪ This appliance reaches high temperatures and
produces steam during use, this could cause
scalds or burns if not used properly.
▪ The steam hose, base station, metal plate at
the bottom of the removable iron pad (2) and in
particular the iron can get hot when used. This
is normal.
▪ Never aim the steam at people or animals.
▪ Do not allow the power cable to come into
contact with the soleplate when it is hot.
▪ Be aware that the system can keep on
steaming for a short additional time after
releasing the steam trigger. This is a normal
function.