Cork handle iron, Ironing without steam, C. vertical steam – Bosch TDS1624000 weiß Flieder Dampfstation Sensixx B10L User Manual

Page 15: Energy saving “eco” setting, Cleaning the boiler, Cleaning & maintenance, Vertical steam

Advertising
background image

15

BOSCH

EN

gl

ISH

Cork HaNDlE IroN

(model dependent)

To get permanent steam, press the lock button

(15*) and slide it backwards until it locks.

To switch off the permanent steam, slide the lock

button forward.

Important:

The steam hose may get hot if you are ironing

for long periods.

Ironing without steam

1. Set the required ironing temperature.

2. Begin ironing but without pressing the steam

release button (12).

C

vertical steam

Never direct the steam jet at garments that

are being worn.

Never aim the steam at people or animals.

1. Set the temperature control to the “

••” or “max”

position.

2. You can steam iron curtains and hanging

garments (jackets, suits, coats...) by holding

the iron in a vertical position and pressing the

steam release button (12).

Operate the iron vertically at a distance of 10 to

20 cm

Energy saving “eco” setting

(model dependent)

If the “eco” steam setting on the steam regulator

(8*) is selected, the energy consumption of the

appliance will be reduced, by means of the

reduction of water consumption and electricity.

A good ironing result can be obtained for most of

the garments.

Use higher settings only for thick and highly

wrinkled fabrics.

Cleaning the Boiler

To extend the life of your steam generator and to

avoid any build up of scale, it is essential that you

rinse out the boiler after several hours of use

(approximately after 50 hours). If the water is

hard, increase the frequency.

Do not use descaling agents for rinsing out the

boiler, as they could damage it.

1. Check that the appliance is unplugged and cold

for more than 2 hours.

2. Unscrew the boiler´s cap (1)

3. Empty the boiler above a sink by holding the

appliance upside down.

4. Fill the boiler with 500 ml of fresh water.

5. Shake the base unit for a few moments and

then empty it completely over a sink or bucket.

6. To obtain the best result, we recommend that

this operation is done twice

7. Close the cap

Cleaning &

maintenance

attention! risk of burns!

always unplug the appliance from the mains

supply before carrying out any cleaning or

maintenance operation on it.

1. After ironing, pull out the plug and allow the

appliance to cool down before cleaning.

2. Wipe the housing, handle and iron body with a

damp cotton cloth.

3. If the soleplate is soiled with dirt or scale, clean

it with a damp cotton cloth.

4. If the cloth is synthetic, it may melt due to the

high temperature on the soleplate (14). Switch

off the steam and rub off any residue

immediately with a thickly folded, dry cotton

cloth.

5. Never use abrasive products or solvents. To

keep the soleplate (14) smooth, you should

avoid hard contact with metal objects. Never

use a scouring pad, or chemicals to clean the

soleplate.

Advertising