Alamo Machete T 7740 - Manual (Page 61)

© 2005 Alamo Group Inc. 2-3
MACHETE
SERVICE BULLETIN No. 952911-1
Alamo Industrial Technical Services Department
1502 East Walnut
Seguin, Texas 78155
830-372-2708
Motor to Spindle Bolt Replacement:
Subject:
Replace motor to spindle bolts with longer bolts. Original Bolts may not keep Motor tight to spindle.
Service Required:
1. Clean the head, especially the area around the Motor and Spindle connection. Remove the four
bolts which attach the motor to the spindle. Lift the motor off the spindle and place it to the side.
2. Place a clean lint free rag over the bearings in the spindle to protect them from contamination.
3. Clean the flange surface of both the motor and spindle of any gasket material or oil.
4. Clean and inspect the threads in the holes, use a thread tap to clean them if needed. Check to
be certain the holes are drilled all the way through the housing, this is important as you will be
installing longer bolts.
5. Check the surface on the motor where the
bolt head tightens. It may be rquired to file
a small portion of this surface in order to
allow for a flat surface onto which the bolt
head can tighten.
6. Remove the rag , and check to be sure that
the spindle is properly lubed.
7. Apply a coating of silicone gasket material
to the motor and spindle housing flanges.
8. Apply a small drop of Locktite to each of the
four new bolts.
9. Install the motor and the four new bolts and
tighten them to the proper torque (120 ft. lbs.).
Parts Required:
Part No. Qty Description
02891800 4 Bolts
02961038 1 Gasket
Models: Machete Boom Mowers
S/N MB21-01002, 01003, 01004, 01006, 01007, 01008
S/N MB24-PT002 through 01007
Date:
Nov. 29, 1995
Bulletin No:
952911-1
(Old # 950014)
Parts:
100 % at Dealer Net
Labor:
0.7 hr. at Dealer registered
Shop Rate
Termination Date:
May. 1, 1996
Old Parts Disposition:
No Returnable Parts
involved
Warranty Compensation will be provided following proper filing of warranty claim in accordance with
the Alamo Industrial Warranty Policy. Claim allowance may vary in accordance with laws governing a
specific region. Any Warranty associated with this service bulletin must be within authorized dates.
02891800 Bolt
02961038
Gasket
Spindle
Figure 1