Poweramp LHP SERIES HYDRAULIC - Manual (Page 23)

21 4111-0012 — Aug 2012
April 2013
OPERATION
NOTE: If end unloading is required, see End
Loading/Unloading Instructions on page 22.
For ramp loading or unloading, the LHP
dock leveler can be operated by using the
RAISE button on the control panel.
1. Check to make sure transport vehicle is positioned
squarely against dock bumpers.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the transport vehicle wheels or use the
truck restraint if available.
Ramp Loading/Unloading Instructions
4. Extend the platform lip onto transport vehicle as
follows:
a. Raise the platform by pushing and holding
RAISE button .
b. Hold the RAISE button until the lip is fully
extended, then release the RAISE button. The
platform will lower until the lip is resting on the
transport vehicle bed.
c. Make sure that the lip is fully extended and
supported on the transport vehicle along the
entire width of the platform with at least 4 in.
(102 mm) of lip contacting the transport vehicle
bed.
7. When loading or unloading is finished, raise the
platform by pushing and holding RAISE button
(A) .
Hold the RAISE button until the lip folds enough
to clear the transport vehicle bed, then release
the RAISE button. The lip will fold and the
platform will return to the cross-traffic position.
8. Remove chocks from transport vehicle wheels or
release the truck restraint if used.
9. Indicate to driver that truck may leave the dock.
A—RAISE Button
A—RAISE Button
5. Proceed with loading or unloading the transport
vehicle.
6. If end loading is necessary, see End Loading/
Unloading Instructions on page 22.
Operating Instructions—Continued
A
A