Poweramp TPR SERIES - Manual (Page 12)

10 4111-0035 — Feb 2012
Aug 2012
INSTALLATION
10
INSTALL ROLLER TRACK PLATE
Install roller track plate onto dock face at specified
location by welding to an embedded steel plate or
by using the fifteen (15) concrete anchors provided
in conjunction with welding to pit steel and a leveler
frame.
If you have questions, contact Systems Technical
Support at (800) 643-5424.
The roller track plate must be plumb with dock face. If
not, use and weld (6) shims 2” wide x 25 5/8” long. If
shims are over 1/2” thick use longer anchors. If shims
need to be 1” thick or more, contact Systems Inc.
Technical Support
NOTE: Trim roller track plate, as necessary, up to a
maximum of 5” from the bottom.
NOTE: Some mechanical dock levelers have an
adjusting nut access hole in the leveler front subframe.
If the TPR vehicle restraint roller track interferes with
the access hole, the track plate must be cut to allow
access.
NOTE: Some levelers are slightly recessed within the
pit and thus require a shim to be inserted between the
roller track plate and the leveler front subframe and
welded in place.
Fifteen (15) concrete anchors are provided with each
TPR vehicle restraint. An anchor must be installed
in each roller track plate hole except for those plug-
welded to embedded steel.
ANCHOR INSTALLATION
INSTRUCTIONS
• Put roller track plate in place.
• Drill hole of 5/8” diameter and minimum of 4-5/8”
deep. Clean out hole.
• Insert anchor and drive flush with roller track
plate, making sure that the threaded wedge is
inserted first. Do not disassemble anchor prior
to installation.
• Install all anchors and torque to 100 ft-lbs.