Poweramp LHP SERIES HYDRAULIC 4.2009 - Manual (Page 22)

OPERATION
End Loading/Unloading — Platform at Cross-Traffic Position.
End Loading/Unloading — Platform at Below-Dock Position.
4. If truck/trailer bed is at or above dock floor level,
leave leveler at the cross-traffic position and
proceed with loading or unloading.
NOTE: If ramp loading is required, see Ramp
Loading/Unloading Instructions on page 19.
End loading or unloading can be done with
the dock at the cross-traffic position or
below-dock position, depending on the height
of the truck/trailer bed.
1. Check to make sure truck/trailer is positioned
squarely against dock bumpers.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the truck/trailer wheels or use the truck
restraint if available.
End Loading/Unloading Instructions
5. Push the Raise button (A) to the platform just
enough to clear the lip keepers.
6. Proceed with loading or unloading.
NOTE: When end unloading is finished and access
to the rest of the truck/trailer is still required,
the platform lip will need to be extended. See
Ramp Loading/Unloading Instructions on
page 19 for further instructions.
7. When the loading or unloading is finished, return
the dock leveler platform to the cross-traffic
(stored) position by performing one of the
following:
OR
• Push the Raise button (A) until the lip clears the
lip keepers. Release Raise button, leveler will
return to the stored or cross traffic position.
8. Remove chocks from truck/trailer wheels or
release the truck restraint if used.
9. Indicate to the driver that the truck may leave the
dock.
Operating Instructions—Continued
4111-0012 — Oct. 2007
Dec 2008
20
A