Poweramp POWERSTOP 4.2009 - Manual (Page 19)

MAINTENANCE
Daily Maintenance
• Daily patrol truck restraint area and clear any
debris to prevent operation issues.
• Check inside and outside lights for proper
operation
Weekly Maintenance
• Operate the truck restraint through the complete
operating cycle to maintain lubrication of parts of
both mechanical and hydraulic restraints.
• Inspect the rear vertical track area (C). The track
area must be kept free of dirt and debris. Build-up
of foreign material in the track areas will cause
abnormal operation.
Clear all dirt and debris from the track areas to
insure proper scissor operation and hook weldment
travel.
NOTE: To thoroughly inspect and clean the scissors
and track areas raise the restraint, remove
two bolts (L), pull shroud & bellows forward to
expose scissors and frame tracks,
Make sure Rear Track Assist Spring (D) is properly
seated at the bottom of the rear track.
NOTE: Rear Track Assist Spring is different part
number for mechanical and hydraulic
PowerStop truck restraint
• Lubricate the following areas with light weight
machine oil:
(A)— Scissor pins and bearings (J&L-all)
M — Reservoir
N —1 in. (25.5 mm) (From Top of
Reservoir)
P — Breather Cap
Q — Fluid Level
• Check reservoir fluid level (Q):
1. Put the truck restraint in the stored position.
2. Turn OFF all electrical power to the truck
restraint..
3. Wipe off plastice tank as needed (P).
4. Measure fluid level. The fluid level should be
approximately 1 in. (25.5 mm) (N) from top of
reservoir (M) with truck restraint stored.
5. Add hydraulic fluid if necessary. Use only
recommended fluid. See previous page.
.6 Install cover
7. Turn ON electrical power.
IMPORTANT
Failure to clean and properly lubricate the truck
restraint will cause abnormal operation.
IMPORTANT
A low fluid level or the use of hydraulic fluids not
equivalent to the fluid types recommended, will
cause abnormal operation of the leveler and WILL
void warranty.
M
N
Q
P
4111-0014 — November 2006
Sept.2007 17
Quarterly Maintenance