Electronics International FP-5L - Manual (Page 22)

Drawn By: Electronics International Inc.
Approved By:
Scale:
Material:
Next Assembly:
P/N: Date: Rev: D/N:
4/15/94
R. R.
R.R.
None
Installation of the Fuel Flow Transducer suspended in the fuel
line between the Fuel Servo and the Flow Divider.
Note: Only applicable for installation on aircraft with a fuel
return line from the Fuel Servio.
0415941
Mounting Procedure:
1. Find a convenient location between the Fuel Servo and Flow
Divider and away from any hot exhaust pipes to suspend the
Fuel Flow Transducer.
2. Remove the fuel hose which goes from the Fuel Servo to the
Flow Divider.
3. Purchase two new hoses: one to be used from the Fuel Servo
to the Fuel Flow Transducer and the other to be used from the
Fuel Flow Transducer to the Flow Divider. There must be
flexible hose in and out of the Fuel Transducer. The hoses
must meet TSO-C53a Type C or D FAA specification. The
new hoses must be the same size as the current hose in the
aircraft. A source of fittings and fabricated hoses is:
Adapter, (1/4" NPT
to Fuel Hose)
(IN)
(OUT)
From the Fuel Servo
To the Flow Divider
Sacramento Sky Ranch Inc.
(916) 421-7672
Fax: (916) 421-5719
Varga Enterprises Inc.
(602) 963-6936
FAX: (602) 899-0324
OR
4. Mount the Fuel Flow Transducer in the fuel line. You must use the FT-90 Fuel Flow Trans-
ducer on any engine over 300 H.P. If the Transducer is mounted within 6" of an exhaust
pipe, the Flow Transducer must be wrapped with Fire Sleeving.
5. Read the Installation Instructions for important installation considerations.
20
B: 7/2/02