Emergi-Lite Survive-All EF40 Series - Manual

Emergi-Lite
Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com 03/14 750.1205 Rev. D
EF39 Nema-4X Die-cast remote heads
1/1
EF39
Nema-4X
Die-cast remote heads
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
All servicing should be performed by qualified service personnel.
2.
Do not mount near gas or electric heaters.
3.
Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
4.
The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
5.
Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
Installation instructions
1. Turn off power.
2. Remove the lens.
3. Install the gasket (8) on the back plate.
4. Connect the lamp wires to the emergency circuit using wire nuts. For
double lamp assembly fixtures, lamps should be connected in parallel,
not in series. Refer to lamp voltage indicated on the unit.
5. Fasten the back plate with 4 screws to either a nema 4X rated junction
box or directly to a recessed junction box making sure the unit is
properly sealed all around (gasket will not guarantee an adequate seal
on all surfaces).
IMPORTANT: The junction box must be Nema 4X rated for the unit to
retain a Nema 4X rating. Plugs must be properly sealed with a sealing
compound.
6. Adjust the lamp assemblies:
- Rotation: hold the lamp assembly and turn it to either side.
- Tilting: hold the lamp assembly and tilt it up or down.
7. Secure the lens to the back plate with the screws provided.
ATTENTION: All lens and junction box screws must be tightened to a
torque of 15inlb.
The screw covers can be installed to prevent the accumulation of
debris on the screws, as required by NSF.
8. Turn on power and check the operation of your lighting fixture.
Lamps replacement
Refer to the relamping label located near the lamp holder or the
recommended maximum wattage. Do not exceed recommended wattage.
Parts List
1. Screw cover (2)
2. Lens screw (2)
3. Lens
4. O-ring (2)
5. Junction box screw (4
required) (not provided)
6. Lamp assembly (1 or 2)
7. Back plate
8. Gasket
9. Weather proof junction
box (not provided).
WARNING:
Risk of Shock.
Disconnect Power before Installation.
Figure 1