FEC AFC1200 - Manual (Page 11)

)(& ,QF
The information displayed in DSP 1 and DSP 2 on the Axis Unit is determined by the ISA Main
Controller Unit's AXIS-DSP switch setting. The two display outputs for each switch setting are
shown below.
PEAK CURRENT CYCLE TIME 8
FINAL TORQUE OFFSET TORQUE 7
ELONGATION ANGLE ELONGATION TORQUE 6
2ND, 3RD, FINAL STEP TIME 1ST STEP TIME 5
3RD TORQUE RATE LOW 3RD TORQUE RATE HIGH 4
2ND TORQUE RATE LOW 2ND TORQUE RATE HIGH 3
1ST TORQUE RATE LOW 1ST TORQUE RATE HIGH 2
FINAL ANGLE PEAK TORQUE 1
DSP 2 OUTPUT
(AXIS UNIT)
DSP 1 OUTPUT
(AXIS UNIT)
DSP SWITCH
(MAIN UNIT)
AXIS UNIT DISPLAY TABLE (FASTENING RESULTS)
Fastening rejects are indicated by dual-color LED's on the affected spindle's Axis Unit, as shown
in the table below.
1ST STEP TIME OVER 2ND, 3RD, FINAL STEP
TIME OVER
TIME
LOW REJECT HIGH REJECT 3RD RATE
LOW REJECT HIGH REJECT 2ND RATE
LOW REJECT HIGH REJECT 1ST RATE
LOW REJECT HIGH REJECT ANGLE
LOW REJECT HIGH REJECT TORQUE
L.E.D. LIT TO ORANGE L.E.D. LIT TO RED REJECT TYPE
AXIS UNIT REJECT DISPLAY TABLE
Chapter 3: System Description
Page 3-11