Fairbanks Series III Bench Scales - Manual (Page 8)

50778 8 07/10 -- Rev. 6
A. Function Keys
= [AutoTare] = Enter
B. Program
Press and hold any key while powering ON. The display will show
CAL.
Press the [UNITS] key to access the program menu.
Press the [UNITS] key for to select the parameter value and
Press the [AutoTare] key to enter the choice and advance to the next step.
The program sequence is as follows:
Displays: Definition
1. Zero Range Or . 0 100% of Capacity
Or . 1 2% of Capacity
2. Auto power off AoFF 0 None
AoFF 1 5 minutes
AoFF 2 10 minutes
AoFF 3 20 minutes
AoFF 4 30 minutes
3. Backlit bL 0 None
bL 1 Active
bL 2 Auto lighting while loading
4. Print Output Pr 0 None
Pr 1 Manual Print
Pr 2 Auto Print
Pr 3 Continuous
Pr 4 Parts Counting Mode
Pr 5 Manual Print 1
Pr 6 Auto Print 1
Pr 7 Parts Counting Mode 1
5. Baud Rate br 9600 Baud Rate = 9600
br 2400 Baud Rate = 2400
6. Counting mode SAMP 0 Counting mode Disable
SAMP 1 Counting mode Enable
Upon programming completion, the instrument will count down 9..8..7..6..5..4..3..2..1..0
and return to the weigh mode.
Section 3: Programming
Note 1: Single print per weighment. Scale must return to zero (0) before the next print cycle
will occur.
= Select